One Coat Direct To Metal Paint for Brush,Roller and Spray Application
One Coat Direct to Metal Paint
One Coat Direct To Metal Paint Brushing / Spraying Enamel Paint is based on a polyurethane enamel resin, suitable for brush, roller and spray applications, to be used as a metal, wood and concrete or brick paint, along with other suitably prepared and primed substrates.
One Coat Direct to Metal Paint Brushing Spraying Enamel paint available in a semi-gloss finish.
Our semi-gloss one coat direct to metal finish, contain anti-corrosive pigments and can be used as a one coat application, to mild steel substrates. This product can be used for many different applications such as metal paint, gates and railing paint, chassis paint, agricultural paint, crane and lifting gear paint, skip & container paint, scaffold marking paint or stillage / pallet paints.
DISCLAIMER: The colours shown on the images are for guidance only. The displayed colour will depend on your monitor and browsers. The finished colour therefore may not be as shown here.
All pictures are for illustration purposes only – 1L & 2.5L cans are not screen-printed cans.
Key Facts• Touch Dry in 2-4 Hours.• Overcoat in 13.20-24 Hours.• Full Dry in 7 Days.• Product exhibits a good chemical resistance.• Thinners if required T0001 White Spirit.• Coverage approx. 8 square metres per litre. we cannot be held responsible for the method of application, absorption of substrate or wastage.• Suitable to be applied with a spray gun or brush/roller• Suitable for primed Metal, primed Fibreglass and Wood
Things to Know• Mix paint well before use and check colour before use.• Two coats are recommended• Can be used as a one coat finish to mild steel (no primer needed)• Make sure substrates are suitably prepared (lightly abraded and degreased)• When applying to pre painted substrates ensure existing paint is in good condition and lightly abraded to provide a key for the new coating to for good intercoat adhesion.
Mixing & Thinning
Make sure you use a broom stick, mixer on a slow running drill or pallet knife that reaches the bottom of the can and mixing should take place for 3-5 mins to ensure all the content is properly mixed together to avoid colour and or drying problems.
Thinners required are White Spirit T0001. If thinning is required when applying by a brush or roller start by gradually adding 5% but do not thin more an 10% as the paint will not cover
As our coatings are heavily pigmented separation can easily occur and you can have colour float, for example a green paint can seem blue before mixing, this is one of the reasons mixing your paint before use is essential.
If applying with a pot gun
Use a 1:2 to 1:4 tip set up thinning by 5% if required.
More thinners may be added to achieve good atomization to achieve better flow of the paint giving a better finish.
If applying with an air assisted or air assisted airless systemUse a 11-13 thou tip no thinners usually required. If thinning is necessary, use around 5% and adjust to personal preference. Set air and paint pressures until good atomization is achieved and fingering (lines in the spray) have blended in.