£11.65 – £31.99
Two Pack High Build
Epoxy Zinc Phosphate Metal Primer
Two Pack High Build Epoxy Zinc Phosphate Metal Primer is suitable for use on metal fabrications where a good hard highly anti-corrosive and chemically resistant primer is required. Some applications may include Structural steel, metal paint, chassis paint, gates and railings paint, agricultural paint, crane and lifting gear paint, skip & container paint, vehicles, scaffold marking paint or on metal stillage & pallets
- Minimum operational temperature is 10 degrees centigrade, paint will not cure below 10 deg c.
- Mix catalyst in to paint very well for 3-4 minutes, a paddle on a slow running drill is recommended.
- Mixing ratio 4:1 (4 parts paint to 1 part catalyst).
- Touch Dry in 2-4 Hours.
- Overcoat in 12-24 Hours.
- Full Dry in 7 Days.
- Product exhibits excellent chemical resistance.
- Thinners if required T0200 Universal Thinners.
- Coverage 8-10 square metres per litre, we cannot be held responsible for the method of application, absorption of substrate or wastage.
- Application by suitable spray application, brush or roller.
- Suitable for mild steel.
Things to know
- Mix paint well before use and check colour before use.
- Make sure substrates are suitably prepared (lightly abraded, degreased and or primed).
- When applying to pre painted substrates ensure existing paint is in good condition and lightly abraded to provide a key for the new coating to provide good intercoat adhesion.
- Temperature will affect drying times and will prevent curing (below 10 deg c). We recommend no less than 10 degrees centigrade to ensure no microscopic moisture build up on substrate. 25 degrees centigrade is the optimal temperature.
- If thinning is required 10% is recommended if brushing. Additional thinners may be needed if spraying to achieve good atomisation of the product.
Always stir any paint well prior to using, especially if using Two Pack products.
Make sure you use a broom stick, mixer on a slow running drill or pallet knife to mix and mixing should take place for 3-5 mins to ensure all the content is properly mixed together to avoid colour and or drying problems.
As our coatings are heavily pigmented separation can easily occur and you can have colour float, for example a green paint can seem blue before mixing, this is one of the reasons mixing your paint before use is essential.
Use a 11-13 thou tip no thinners usually required.If thinning is necessary use around 10% Set air and paint pressures until good atomization is achieved and fingering (lines in the spray) have blended in.