Quick Drying Agricultural Metal Primer High Build Zinc Phosphate A/C for Spraying

£16.65

Clear

Description

Quick Drying Agricultural High Build Zinc Phosphate Metal Primer


Quick Drying Agricultural High Build Zinc Phosphate Metal Primer product name is Europrime 1 high build zinc phosphate based on a quick drying enamel resin, suitable for spray application, brush and roller application in small areas, to be used on mild steel along with other suitably prepared and primed substrates.

Quick Drying Agricultural High Build Zinc Phosphate Metal Primer can be used in many different ways a few variations are structural steel and agricultural fabrications and metal work.


Key Facts

  • Touch Dry in 2o-30 Minutes.
  • Overcoat in 1-24 Hours.
  • Full Dry in 7 Days.
  • Thinners if required T1000 Xylene or T0200 Universal Thinners.
  • Coverage 8-10 squared metres per litre, we cannot be held responsible for the method of application, absorption of substrate or wastage.
  • Application by suitable spray application or by brush / roller in small areas.
  • Suitable for mild steel and other suitably primed substrates.


Things to know

  • Mix paint well before use and check colour before use.
  • Make sure substrates are suitably prepared (lightly abraded, degreased and or primed).
  • When applying to pre painted substrates ensure existing paint is in good condition and lightly abraded to provide a key for the new coating to provide good intercoat adhesion.
  • Temperature will affect drying times but will not prevent curing. We recommend no less than 10 degrees centigrade to ensure no microscopic moisture build up on substrate. 25 degrees centigrade is the optimal temperature.
  • If thinning is required 10% is recommended if brushing. Additional thinners may be needed if spraying to achieve good atomisation of the product.

 

Always stir any paint well prior to using, especially if using Two Pack products.

Make sure you use a broom stick, mixer on a slow running drill or pallet knife to mix and mixing should take place for 3-5 mins to ensure all the content is properly mixed together to avoid colour and or drying problems.

As our coatings are heavily pigmented separation can easily occur and you can have colour float, for example a green paint can seem blue before mixing, this is one of the reasons mixing your paint before use is essential.

 

 


Conventional 600 CC Pot Gun

If applying with a pot gun
Use a 1:2 to 1:4 tip set up thinning by 10% if required.
More thinners may be added to achieve good atomization to achieve better flow of the paint giving a better finish.
More thinners may be added to achieve good atomization to achieve better flow of the paint giving a better finish.

 

 


Mag 500 Airless Spray Gun
If applying with an airassisted or airassisted airless system
Use a 11-13 thou tip no thinners usually required.If thinning is necessary use around 10% Set air and paint pressures until good atomization is achieved and fingering (lines in the spray) have blended in.

Additional information

Size

Primer Colours

BLACK, WHITE, RED OXIDE, BUFF, GREY

You may also like…

Discuss this post ?

Your email address will not be published. Required fields are marked *

*

*