Quick Drying Agricultural Enamel For Spray Application

£22.50£25.60

Can’t find the colour or gloss level your looking for?

Click here for our full colour range and finishes.

Clear

Description

DISCLAIMER: The colours shown on the images are for guidance only. The displayed colour will depend on your monitor and browsers. The finished colour therefore may not be as shown here.

All pictures are for illustration purposes only

 

Quick Drying Metal Paint

Quick Drying Metal Paint is based on a quick drying resin suitable for spray application however this can be brushed only on small surface areas which can be used on mild steel along with other suitably prepared and primed substrates.

We offer an anti-corrosive high build zinc phosphate primer (Europrime 1) available in Black, Buff, Grey, Red Oxide and White.

Quick Drying Gloss finish is Eurospeed 1.

Our semi-gloss finish contains anti-corrosive pigments and can be used as a one coat application direct to metal, to mild steel substrates.

 

Quick Drying Metal Paint can be used on the following:

    • • Containers
      • Metal
      • Skips
      • Porter Cabins
  • Key Facts
  • • Touch Dry in 20-30 Minutes.
  • • Overcoat in 12-24 hours.
  • • Full dry in 7 days.
  • • Thinners if required T1000 Xylene
  • • Coverage approx. 8 square meters per litre, we cannot be held responsible for the method of application, absorption of substrate or wastage.
  • • Suitable for metal and other suitably primed substrates.

 

Things to Know

  • • Mix paint well before use and check colour before use.
    • Make sure substrates are suitably prepared (lightly abraded, degreased and or primed).
    • Semi-Gloss can be used as a one coat finish to mild steel as they contain anti corrosive properties
    • For the best anti-corrosion protection to metal use a primer first.
    • When applying to pre painted substrates ensure existing paint is in good condition and lightly abraded to provide a key for the new coating.
    • This product cannot be used over a brushing, white spirit based enamel’s as it will attack it

 

 

Conventional 600 CC Pot Gun

 

If applying with a pot gun

Use a 1:2 to 1:4 tip set up thinning by 10% if required.

More thinners may be added to achieve good atomization to achieve better flow of the paint giving a better finish.

More thinners may be added to achieve good atomization to achieve better flow of the paint giving a better finish.

 

 

 

 

Mag 500 Airless Spray Gun

If applying with an air assisted or air assisted airless system
Use a 11-13 thou tip no thinners usually required. If thinning is necessary use around 10% set air and paint pressures until good atomization is achieved and fingering (lines in the spray) have blended in.

Additional information

Size

Gloss-Level

,

QD Colours

, , , , , , , , , , , ,

Discuss this post ?

Your email address will not be published. Required fields are marked *

*

*