One Coat Direct To Galve Paint Primer/Finish

£16.00£42.49

Clear

Description

One Coat Galve Paint Primer Finish

One Coat Galve Paint Primer Finish is based on a quick drying enamel resin, suitable for spray applications and brush application in small areas, to be used on mild steel or galvanizing along with other suitably prepared and primed substrates.

This paint is supplied as an anti-corrosive high build zinc phosphate one coat primer/finish as a semi-gloss finish. That contains anti-corrosive pigments and can be used as a one coat application, to galvanizing and mild steel substrates.

One Coat Galve Paint Primer Finish can be used in many different ways a few variations are direct to galvanizing paint, metal paint, chassis paint, gates and railings paint, agricultural paint, wood paint, crane and lifting gear paint, skip & container paint, scaffold marking paint or stillage / pallet paints.


Key Facts

To apply use a light dust coat thinned a minimum of 10 %. Followed by a full coat for the best adhesion.
Touch Dry in 2o-30 Minutes.
Over coat in 2-24 Hours.
Full Dry in 7 Days.
Provides excellent mechanical adhesion to galvanizing and mild steel
Use caution when over coating old paint as a reaction may occur if a white spirit coating has been applied previously.
Thinners if required T1000 Xylene or T0200 Universal Thinners
Coverage 8-10 squared metres per litre. We cannot be held responsible for the method of application, absorption of substrate or wastage.
Application by suitable spray application or by brush in small areas
Suitable for metal and other suitably primed substrates


Things to know

First off all mix paint well before use then check colour before use.
The substrate needs to be suitably prepared (lightly abraded, degreased and or primed).
When applying to pre painted substrates ensure existing paint is in good condition and lightly abraded. This is to provide a key for the new coating to provide good intercoat adhesion.
Temperature will affect drying times but will not prevent curing. We recommend no less than 10 degrees centigrade to ensure no microscopic moisture build up on substrate. 25 degrees centigrade is the optimal temperature.
Suitable for use on steel, wood, concrete, and other suitably prepared and primed substrates.
If thinning is required 10% is recommended if brushing. Additional thinners may be needed if spraying to achieve good atomisation of the product.


 

Always stir any paint well prior to using, especially if using Two Pack products.

Make sure you use a broom stick, mixer on a slow running drill or pallet knife to mix and mixing should take place for 3-5 mins to ensure all the content is properly mixed together to avoid colour and or drying problems.

As our coatings are heavily pigmented separation can easily occur and you can have colour float, for example a green paint can seem blue before mixing, this is one of the reasons mixing your paint before use is essential.

 

 


Conventional 600 CC Pot Gun

If applying with a pot gun
Use a 1:2 to 1:4 tip set up thinning by 10% if required.
More thinners may be added to achieve good atomization to achieve better flow of the paint giving a better finish.
More thinners may be added to achieve good atomization to achieve better flow of the paint giving a better finish.

 

 


Mag 500 Airless Spray Gun
If applying with an airassisted or airassisted airless system
Use a 11-13 thou tip no thinners usually required.If thinning is necessary use around 10% Set air and paint pressures until good atomization is achieved and fingering (lines in the spray) have blended in.

Additional information

Size

, ,

One Reply to “One Coat Direct To Galve Paint Primer/Finish”

Comments are closed.