Machine Paint | Machinery Enamel


Cannot find the colour or gloss level your looking for?

Click here for our full colour range and finishes.




DISCLAIMER: The colours shown on the images are for guidance only. The displayed colour will depend on your monitor and browsers. The finished colour therefore may not be as shown here.

All pictures are for illustration purposes only – 1 & 2.5 Litre cans are not screen-printed cans.


Machine Enamel Paint


Machine Enamel Paint is based on a polyurethane enamel resin, suitable for brush, roller, and spray applications. Our stock colours are standard high gloss finish.

Machine Enamel Paint can be used in many different ways a few variations are metal paint, gates and railing paint, chassis paint, agricultural paint, wood paint, crane and lifting gear paint, skip & container paint, scaffold marking paint or stillage / pallet paints.


Key Facts

• Touch Dry in 2-4 Hours.
• Overcoat in 12-24 Hours.
• Full Dry in 7 Days.
• Product exhibits a good chemical resistance.
• Thinners if required T0001 White Spirit.
• Coverage approx. 8 square metres per litre. we cannot be held responsible for the method of application, absorption of substrate or wastage.
• Suitable to be brushed and rolled and by spray gun


Things to Know

• Mix paint well before use and check colour before use.
• For the best anti-corrosion protection to metal use a primer first.
• Make sure substrates are suitably prepared (lightly abraded, degreased and or primed).
• When applying to pre painted substrates ensure existing paint is in good condition and lightly abraded to provide a key for the new coating to offer good intercoat adhesion.



Mild Steel – If you are painting mild steel you will need our Metal Primer to view this please click here 

Fibreglass – If the fibreglass is bare you will need a fiberglass primer. Click here

Galvanised Steel – Once you have treated the galvanised steel with Mordant Solution you will need our Metal Primer. Click here

Aluminium – The primer suitable for aluminium is One Pack Etch Primer. Click here 



Mixing & Thinning 

Make sure you use a broom stick, mixer on a slow running drill or pallet knife that reaches the bottom of the can and mixing should take place for 3-5 mins to ensure all the content is properly mixed together to avoid colour and or drying problems.

Thinners required are White Spirit T0001. If thinning is required when applying by a brush or roller start by gradually adding 5% but do not thin more an 10% as the paint won’t cover

As our coatings are heavily pigmented separation can easily occur and you can have colour float, for example a green paint can seem blue before mixing, this is one of the reasons mixing your paint before use is essential.

Conventional 600 CC Pot Gun

If applying with a pot gun
Use a 1:2 to 1:4 tip set up thinning by 10% if required.
More thinners may be added to achieve good atomization to achieve better flow of the paint giving a better finish.
More thinners may be added to achieve good atomization to achieve better flow of the paint giving a better finish.



Mag 500 Airless Spray Gun
If applying with an airassisted or airassisted airless system
Use a 11-13 thou tip no thinners usually required.If thinning is necessary use around 10% Set air and paint pressures until good atomization is achieved and fingering (lines in the spray) have blended in.

Additional information


, ,

Stock Colours 2

, , , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,

You may also like…

Discuss this post ?

Your email address will not be published. Required fields are marked *