Concrete Floor Paint

£12.00£25.60

Clear
SKU: PU FP ET2 Category:

Description

 

Floor Paint

Concrete Floor Paint is suitable for use on concrete floors where light foot traffic will occur. Perfect for use for home garages, factory walkways, warehouse and shop floors to provide a protective coating with chemical resistance also to be uses as a dust sealer for concrete floors.

Concrete Floor paint is a single pack, White Spirit based paint which can be also used on Metal, Wood, Stone, and Brick floors which offers a good chemical resistance with a high gloss finish.

This is paint is not suitable if you will be having vehicles using the area i.e. car’s, motor bikes and forklift trucks.

Like any painted surface when wet is slippery, we do offer a non-slip version which is a rough textured finish. Click here for our Non Slip Floor Paint.

 

Key Facts

• Touch Dry in 2-4 Hours
• Overcoat in 12-24 hours
• Full dry in 7 days
• Two coats always recommended
• Coverage approx. 8 square meters per litre, we cannot be held responsible for the method of application, absorption of substrate or wastage.
• Suitable to be applied by brush and roller.

 

Things to Know

• Mix paint well before use and check colour before use.
• Make sure substrates are suitably prepared (lightly abraded, degreased and or primed).
• When applying to pre painted substrates ensure existing paint is in good condition and lightly abraded to provide a key for the new coating to offer good intercoat adhesion.

• If you are painting new concrete, it will be need to be laid for at least 3 months prior to painting.

 

Thinning Key Properties To Look For In Concrete Floor Paint

• Thinners required are White Spirit T0001
• If thinning is required start 5% adding the thinners gradually do not thin more than 10% as the paint will not cover.
• If you are painting bare concrete, you will find that it will be porous we recommend that on your first coat thin 20% to ensure this impregnates the concrete. Then after 12-24 hours apply the second coat un thinned.

 

 

Mixing

Make sure you use a broom stick, mixer on a slow running drill or pallet knife that reaches the bottom of the can. Mixing should take place for 3-5 mins to ensure all the content is properly mixed to avoid colour and or drying problems.

As our coatings are heavily pigmented separation can easily occur and you can have colour float, for example a green paint can seem blue before mixing, this is one of the reasons mixing your paint before use is essential.

Additional information

Size

, ,

Stock Colours 2

, , , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,

You may also like…

Discuss this post ?

Your email address will not be published. Required fields are marked *

*

*