Chassis Paint

£12.00£22.50

Cannot find the colour or gloss level your looking for?

Click here for our full colour range and finishes.

Clear

Description

DISCLAIMER: The colours shown on the images are for guidance only. The displayed colour will depend on your monitor and browsers. The finished colour therefore may not be as shown here.

All pictures are for illustration purposes only – 1 & 2.5 Litre cans are not screen-printed cans.

 

Chassis Paint

Chassis Paint based on a Polyurethane based resin which provides a tough film with good adhesion, gloss, and weathering properties.

When fully dry the Chassis paint coating exhibits good resistance to petrol, paraffin, and mineral oil spillage.

Semi-gloss & Matt can be used as one coat paints as they contain anti-corrosive products.

Chassis Paint is suitable for all vehicle chassis for example military and Land rover vehicles, agricultural, commercial vehicles and trailers.

Key Facts

• Touch Dry in 2-4 Hours
• Overcoat in 12-24 Hours
• Full Dry in 7 Days
• Thinners if required T0001 White Spirit
• Coverage 8-10 squared metres per litre, we cannot be held responsible for the method of application, absorption of substrate or wastage.
• Application by suitable spray application, brush or roller
• Suitable for metal, wood, concrete and other suitably primed substrates

Things to Know

• Mix paint well before use and check colour before use.
• For the best anti-corrosion protection to metal use a primer first.
• Make sure substrates are suitably prepared (lightly abraded, degreased and or primed).
• When applying to pre painted substrates ensure existing paint is in good condition and lightly abraded to provide a key for the new coating to offer good intercoat adhesion.

 

Primer

Mild Steel – If you are painting mild steel you will need our Metal Primer to view this please click here

Fibreglass – If the fibreglass is bare you will need a fiberglass primer. Click here

Galvanised Steel – Once you have treated the galvanised steel with Mordant Solution you will need our Metal Primer. Click here

Aluminium – The primer suitable for aluminium is One Pack Etch Primer. Click here

Mixing & Thinning

Make sure you use a broom stick, mixer on a slow running drill or pallet knife that reaches the bottom of the can and mixing should take place for 3-5 mins to ensure all the content is properly mixed together to avoid colour and or drying problems.

Thinners required are White Spirit T0001. If thinning is required when applying by a brush or roller start by gradually adding 5% but do not thin more an 10% as the paint won’t cover

As our coatings are heavily pigmented separation can easily occur and you can have colour float, for example a green paint can seem blue before mixing, this is one of the reasons mixing your paint before use is essential.


Conventional 600 CC Pot Gun

If applying with a pot gun
Use a 1:2 to 1:4 tip set up thinning by 10% if required.
More thinners may be added to achieve good atomization to achieve better flow of the paint giving a better finish.
More thinners may be added to achieve good atomization to achieve better flow of the paint giving a better finish.

 

 


Mag 500 Airless Spray Gun
If applying with an airassisted or airassisted airless system
Use a 11-13 thou tip no thinners usually required.If thinning is necessary use around 10% Set air and paint pressures until good atomization is achieved and fingering (lines in the spray) have blended in.

Additional information

Size

, ,

Military Vehicle Colours

, , , , , , , , , , , , , , , , , , , , ,

You may also like…

Discuss this post ?

Your email address will not be published. Required fields are marked *

*

*